Supplies local configuration for Cisco TrustSec parameters.Įnables the TrustSec egress or ingress reflector. Enables Cisco TrustSec caching andĬonfigures RADIUS server list configuration.Ĭonfigures local device security group tag.Įnables subnet SGT derivation for switched (layer 2) traffic and enables Cisco Meta Data (CMD) tagging exemption for incoming and outgoing control packets.Īdds Cisco TrustSec flow objects to a Flexible NetFlow flow record.Ĭisco TrustSec Interface Configuration CommandsĮnters CTS dot1x Interface Configuration mode (config-if-cts-dot1x).Įnables and applies traffic and exception policies to Cisco TrustSec Layer 3 Transport gateway interfaces. Maps IP addresses, Layer 3 interfaces, and VRFs to SGTs. Specifies traffic and exception policies for Cisco TrustSec Layer 3 Transport gateway interfaces. Regenerates the Pairwise Master Key used by the Security Association Protocol (SAP),Ĭisco TrustSec Global Configuration CommandsĬonfigures Cisco TrustSec global authorization configuration.Įnables caching of TrustSec authorization and environment-data information to DRAM and NVRAM.ĭefines Cisco TrustSec keystore behavior. Refreshes environment, peer and RBACL policies. Inserts Cisco TrustSec device ID and password into the keystore. Note Effective with Cisco IOS Release 15.1(1)SY, this command is not available in Cisco IOS software. Initiates password change with AAA server. default timer reauthentication (cts interface).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |